![]() ![]() Measured value of the temperature sensor.įor plausible values even with the display always on, its brightness must not be set higher than 30%.Īs long as the output is active the display will stay on, even if the device is idle. When battery powered, the display and status LEDs cannot be controlled because the device is in idle state. Afterwards, the buttons are fully functional. ![]() The device needs about 30 seconds to calibrate and should not be touched. The following document contains a list and explanation of the possible commands:Īfter inserting the battery, the device performs a calibration of the keypad. This way the created commands can be tested:Ĭommands for numerous blocks can be created according to the same principle. In the Simulation/Liveview a representation of the Touch Pure Flex can be opened. Now the Touch Pure Flex is dragged onto the desired lighting controller, the API Connector is created automatically: The "MENU" command then enables a menu selection of the moods on the Touch Pure Flex via the display and the arrow keys. In the following example, we select a lighting controller and the input for selecting the mood. To change or create new commands, click on the respective button and open the API Command Generator in the corresponding line via the cogwheel: If commands were also defined in the Online Configurator, these are now also assigned to the device.Īlternatively, the individual button inputs are also available after downloading the configuration. Via "View/Configure button assignment" a window opens, here the respective Config ID (from the label of the Touch Pure Flex) is entered.Īfter that, the Touch Pure Flex configuration is downloaded from Loxone and the button icons are visible in the dialog. If the supply method is changed later, the device must be deleted from the configuration and paired again. The device must therefore be paired in the same supply method in which it is to be operated later. The available functions differ depending on whether the device is battery operated or connected to an external power supply. If no connection to a Miniserver can be established for five minutes, pairing mode will be activated for a limited time. To activate the pairing mode manually, switch off the power for 10 seconds, then switch it back on. In delivery state, pairing mode will be active after the power supply has been established. ![]() To release the device, pull firmly on the bottom to disengage the latch.Ī suction cup can be used to detach the device from the aluminum frame. The Touch Pure Flex is first inserted into the top of the frame and then snapped into place at the bottom. Two markings at the top edge of the housing help with positioning: It must be attached above the terminals once connected. Optionally, a small power supply unit can be installed in the box.Ĭonnect the power supply (orange/white plug-in terminal).įor battery operation, remove the orange/white plug-in terminal and insert two AAA batteries.Ī self-adhesive cover is included in the delivery to protect against water. When using an external power supply, a junction box is recommended to tuck away connecting wires or a spare loop behind the device. Alternatively, the aluminum frame can be used, available separately. In addition, the Touch Pure Flex also serves as a Room Comfort Sensor thanks to the integrated temperature and humidity sensor.ĭatasheet Touch Pure Flex Air Table of Contentsįasten the included plastic mounting frame to a flat surface or to a installation box. With the integrated LED matrix display, as well as 3 status LEDs, menus, values, texts and states can be displayed. The Touch Pure Flex is your 100% personalized control device with up to 12 freely definable and positionable touch points. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |